Gets the object that can extract the important bytes from the stream. Do not modify any properties on the extractor directly, always use ChangeSource(IConnector, IMessageBytesExtractor, IRawMessageTranslator) to perform configuration changes.

Gets a value indicating whether the listener is connected to the source of aircraft message data.

Gets the connector that is handling the connection for the listener. Do not modify any properties on the connection directly, always use ChangeSource(IConnector, IMessageBytesExtractor, IRawMessageTranslator) to perform configuration changes.

Gets or sets the number of milliseconds that must elapse after the last message from a given ICAO on a receiver before that receiver is no longer considered to be the only source of messages for that ICAO.

Gets or sets a value indicating whether messages from aircraft are ignored until they transmit a position.

Gets or sets a value indicating whether exceptions thrown by the message translator cause a disconnection and raise ExceptionCaught or whether they are ignored.

Gets or sets a value indicating that this is a satcom feed.

Gets the list of listeners that will be merged into a single feed.

Gets the object that translates raw messages into Port30003 format messages. Do not modify any properties on the translator directly, always use ChangeSource(IConnector, IMessageBytesExtractor, IRawMessageTranslator) to perform configuration changes.

Gets or sets the identity of the receiver that is controlling this listener.

Gets or sets the name of the receiver that is controlling this listener.

Gets the statistics for the listener.

Gets a count of the total number of messages that could not be translated.

Gets a count of the total number of messages received by the object.